主要使用建筑物内各种导电,抗静电弹性地板(PVC,橡胶)卷材,片材地板与基础物粘接。
It can be used in the buildings for electic conductivity,anti-electrostatic bonding for plastic or Rubber sheet and tile to substrate Special for heavy-duty floor.
施工方法
使用前应搅拌均匀，建议用专用锯齿刮刀均匀地涂刮，铺展后凉胶时间20-60分钟(根据气候温度不同，可用手指触摸判断表干情况)即可铺设上述地板材料。
铺下地板后先用软木板，后用50kg以上滚筒滚压以排除残余的空气，确保胶水全部粘结附到地板背面。
24小时后可固化,48小时后可步行。
Application Instruction
Stir thoroughly the product before use,apply it evenly on the surface of substrate by using K or TL toothed trowel. After short open time of 20-60 mins, the substrate is ready to accept above flooring material.
After the flooring material is applied on the substrate rub the surface by wood plate and roll by 50kg roller to remove entranced air under the flooring material. Make sure that adhesive has transferred to the back of the flooring material.
The adhesive will be dried after 24hrs, and set to foot traffic after 48hrs.
理论涂布量 Theoretical application rate
K齿刮板 K Tooth trowel: 200g/m²
TL齿刮板 TL Tooth trowel: 250g/m²
保质期 Quality Grarantee Period
在0-40℃库房内储存，保质期为12个月。
12 months if stored in 0-40℃.
注意事项 Notes
本品在运输，储存和施工过程中防止严寒及阳光暴晒，施工温度不低于5℃。
The product should be protected against frost and direct light during transportation, storage and application.Application temperature should not be lower than 5℃.