HT19是一款用于需要快速干燥,提早强度,地面精找平的特种高性能自流平水泥产品。该产品具有现场施工便捷快速干燥(1小时可上人,2-4小时可铺装地板),干燥强度高,低收缩率等优点,非常适合用于老旧地面翻新,HT19新建项目对工期时间要求紧迫,快速修补有较高强度要求等工地,能够满足各种要求高,工期短的施工需求。
HT16 is an advanced cement and polymer based leveling and smoothing compound. HT16 is formulated for experienced commercial contractors to smooth and level large commercial and retail areas. HT16 is very suitable for normally trafic, quick-seting and comprehensive solution to meet the high requirements of surface.
施工方法 Application Instruction
1、将4.25升冷净水放入干净的容器中。将袋装物（25kg）倒入容器轻快搅拌并混合至浓稠流体状态中并无团块状。Put 4.25 litres of cold clean water into a clean container. Sprinkle in the sack contents (25kg) whilst stirring briskly and mix to a thick- fluid. Lump-free consistency. Use a drill or mixer fitted with a Mixing Paddle. Do not mix too thinly.
2、将混合好的自流平水泥倒在待施工的区域，用齿耙将材料均匀地铺在地面上，所需厚度根据施工需要调整。使用专用放气滚筒消除气泡。Pour the mixture on the area to be applied, spread the material uniformly to Required thickness using toothed rake. It is the next step to remove entranced air by particular roller.
3、20℃干燥时间约24-48小时。干燥后可采用40-60磨砂纸打磨，提高了表面吸收性。较差的空气流动和较低的温度将影响干燥时间。
Drying time at 20℃ is approx 24-48 hours. Abrading using 40-60 grit sanding paper improves both the surface quality and the absorbency. Poor air-flow and lower temperatures will significantly affect drying times.
覆盖率 Coverage
约1.7公斤粉末/毫米/平米
1.7kg powder/mm/㎡
施工厚度 Thickness
可应用于3-30mm厚度施工
applied from 3mm to 30mm
抗压强度 Compressive strength
40Mpa
抗折强度 Tensile bending strength
8Mpa
可施工时间 Working time
约20分钟
about 20mins
保质期 Quality Grarantee Period
在0-40℃库房内储存，保质期为6个月。
6 months if stored in 0-40℃.
注意事项 Notes
本品在运输、储存中应严格防雨防潮，施工温度不低于5℃。
The product should be protected against frost and direct sun light during transporation, storage and application. Application temperature should not be lower than 5℃.